Back in September when I was rebuilding the shop roof, I replaced the motion sensor floodlight that had been up there for 8 years with a new one, this light, from Home Depot. The old one was working but the lense cover was pretty cracked so I decided I'd just stick up a new light as part of the project.
The damm thing doesn't work!
I've had this light off the wall 3 times now. I've purchased and installed a second sensor. I've bench checked this light and it seems to work just fine. I've rehung it on the wall, 3 times, and it seems to work for a week or two, then it defaults to an "always on" mode. I've followed the reset instructions- repeatedly, without success. I'm using the same wiring that I used with the previous light.
I'm really fed up! I need a light back there to provide illumination on the front of the shop but this light is not working for me. I haven't decided what my next solution is going to be but I've got to have a new solution for my shop!
No comments:
Post a Comment
This is your opportunity to speak up...